Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Slotted-Span Fridge Door Pull Handle
A 170 mm replacement pull handle for a refrigerator or freezer with a cracked or snapped handle. The two feet have 10 mm slots for M4 or #8 screws, so it fits screw spacings anywhere from 136 to 156 mm without drilling new holes. The bar stands 26 mm off the door to leave room for your fingers, and the screw heads sit in 9 mm counterbore channels you reach from the front. It prints flat, so the pulling force runs along the layers instead of across them.
Fridge Door Bin Hook Tab Repair Saddle
This saddle replaces the hook tab when one snaps off a fridge door bin. It slides over the bin's side wall in a 5 mm channel, and two M3 set screws in M3 heat-set inserts clamp it to any wall from 1.5 to 4.5 mm thick. A new hook with a 10 mm wide, 11 mm deep throat then drops over the door's moulded shelf rib. The part measures 27 x 30 x 36 mm.
Fridge Door Hinge Pin Socket Plate
A screw-on repair plate that gives a sagging refrigerator or freezer door a fresh hinge-pin socket when the moulded nylon pocket has worn oval. The 72 x 52 x 5 mm plate carries a ribbed 22 mm boss with an 8.3 mm slip-fit socket 12 mm deep for a standard 8 mm hinge pin, a 22 mm x 2 mm relief recess underneath so it sits flat over the chewed-up original boss, and four 4.5 mm holes on a 56 x 38 mm pattern for #8 screws or M4 bolts.
Fridge Bin Retainer Rod Bracket
A replacement end bracket for the bottle-retainer bar on a refrigerator door bin: it slides over the bin's top edge, grips walls 2–5.5 mm thick with an M3 set screw in a heat-set insert (4.0 mm bore) plus two 45° bite ridges, and carries an 8 mm smooth rod or dowel in a teardrop 8.4 mm bore. Print two, cut a rod to the bin width, and skip the $40–60 whole-bar assembly that is discontinued on older fridges. Each bracket is 32.5 x 40 x 22 mm with a 40 mm long clamping jaw.