Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Mower Height Lever Set-Screw Grip
Replacement grip for a push-mower or zero-turn height-adjust lever whose plastic knob has cracked off. It is 90 x 36 x 18 mm and has a 24 x 7.5 mm slot, 50 mm deep, that takes any flat bar up to 24 x 7 mm or round rod up to 7 mm. Two M4 set screws in brass heat-set inserts (5.5 mm bores) clamp it to the bar, so you don't need the exact OEM size.
Universal Toaster Lever Slide-On Knob
This knob replaces a broken toaster lever knob. It is 36 x 26 x 18 mm, with a cross-shaped socket that takes a flat steel lever tab up to 12.5 x 3 mm or a round stem up to 6 mm, and an M3 heat-set insert and grub screw clamp it to whichever one your toaster has. OEM lever knobs are usually discontinued, and this one means you don't have to throw out a working toaster over a snapped piece of plastic.
Tub Spout Diverter Set-Screw Pull Knob
A replacement pull-up knob for a tub spout diverter whose original knob snapped off or stripped. It has a 32 mm finger-grip cap and a 6.3 mm stem socket, 17 mm deep, clamped by an M3 set screw through a captured M3 nut. Because the set screw grips rather than a thread, it fits any round or stripped lift rod from about 3.5 to 6 mm, so you don't have to replace the whole spout. Print it in PETG or ASA because it sits near hot water.