Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Three-Lane 60° Taco Fill-And-Serve Stand
A stand with three V-shaped lanes that holds hard or soft taco shells upright while you fill and serve them. It also holds pitas, hot-dog buns and rolled wraps. Each lane has 60° walls, a 10 mm flat bottom and a 52 mm opening at the top. The stand measures 171 x 60 x 40 mm. It is a ribbed shell with hollow tunnels under each ridge, so it uses about 75 cm³ of plastic, prints with no supports and won't tip over when the shells are loaded.
Flagged: contact with food. Not for safety-critical use without independent engineering review.
Ribbed Toilet Plunger Drip Tray
A round drip tray, 170 mm across and 22 mm tall, for a standard cup or flange toilet plunger. Eight radial ribs hold the rubber cup 8.4 mm above the floor, so air can dry it and water drains into the well instead of pooling on the floor tiles.