Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Snap-On RJ45 Snagless Boot Four-Pack
Four replacement snagless boots for Ethernet patch cables, joined on a snap-off sprue. Each boot clips onto the cable from the side through a 4.4 mm slit, so you never have to cut the plug off. Each boot has a 6.2 mm bore for Cat5e/Cat6 cable about 5.5–6.5 mm thick. A slit 12.6 x 12.6 mm shroud slides over the back of a standard 11.7 mm-wide 8P8C plug. A 1.8 mm flex tongue covers the latch trigger so it can't snag in a bundle, and you press the tongue to release the plug. The tapered 24 mm tail stops the cable bending sharply at the crimp.
Single-Gang Pre-Terminated Cable Pass-Through Plate
This single-gang wall plate (70 x 114 mm, the 2.75 x 4.5 in standard size) has a 28 x 20 mm port that a moulded RJ45 plug or F-connector can pass through. An 8 mm side slit lets you slip the plate over Cat6 or RG6 that is already pulled, so you don't have to cut off factory connectors. The screw holes are slotted 4.2 mm wide over 79.5–83.8 mm centres, which covers the standard 83.3 mm (3-9/32 in) spacing of US device boxes and low-voltage brackets with #6-32 screws.
Zip-Tie Clamshell Cable Boot Splint
This tapered two-half splint replaces the cracked molded boot behind an RJ45 patch cable or USB plug. It clamps onto cables from 4.5 to 6.5 mm OD: the bore is 6.6 mm with five crush ribs that narrow it to 4.8 mm, and two 4.2 mm zip-tie grooves hold the halves closed. It is 45 mm long and tapers from 18 to 10 mm OD. Both halves print flat as one piece joined by snap-off sprues, so the plug never has to pass through it and a working cable doesn't get binned.
Dual Keystone Surface Mount Box
A printed surface-mount "biscuit" box that holds two standard keystone modules (RJ45, USB, HDMI, F-type) in 14.8 x 16.3 mm snap openings through a 2.0 mm front panel — the 14.5 x 16.0 mm cutout and panel thickness keystone latches are built for. Outer size 72 x 40 x 34 mm, 22 mm port pitch, two 4.5 mm wall-screw bores (M4 or #8 wood screw, 4.2 mm shank) sunk at the back plate behind a 9 mm screwdriver channel, plus 12 x 12 mm cable notches on both long walls and a zip-tie strain-relief slot pair.