Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Garage Door Emergency Release T-Handle
A red replacement for the T-handle on a sectional garage door opener's emergency-release cord. It has a 110 mm grip with finger scallops and a 50 mm stem. The cord runs through a 45° diamond channel that fits rope up to about 6.7 mm (the usual 5–6 mm opener cord). You can anchor it with a knot in the open 16 mm pocket, lock it with an M4 self-tapping pinch screw, or use both. The part prints flat so the pull load runs along the layers instead of across them.
Print-In-Place Rope Turning Block
A surface-mount rope pulley with a 34 mm sheave that prints in place on its own 9 mm axle post — no bearings, no assembly. The V-groove takes 5–6 mm rope (clothesline, tarp ridgeline, ceiling hoist, kayak or gate pull line) and redirects it up to 180°; the 50 x 58 mm base screws down with four M5 / #10 wood screws through 5.5 mm holes, and the capture cap keeps the rope in the groove even when the line goes slack.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Captive Cone Tarp Clamp
A grommet-free tarp clamp that grips any tarp, canopy or greenhouse film anywhere along its edge: drape the fabric over the 19.4 mm funnel mouth and press the captive cone plug (Ø8 → Ø22.7 mm over 23 mm) down into it — the plug's steeper 16.7° taper wedges the fabric against the funnel's 11.3° wall, and because the crown is wider than the mouth the plug prints in place and can never be lost. The 68 x 32 x 23 mm body carries a 10.4 mm rope eye for paracord, bungee hooks or an S-hook, plus a 5.5 mm M5 clearance hole so it can bolt directly to a post or frame instead.
Print-In-Place Rope Cam Cleat
A three-piece print-in-place cam cleat that jams 4–8 mm rope or paracord one-way for tarps, roof racks, awnings and van-life tie-downs — pull to tension, lift the line out to release. Base is 76 x 54 x 16 mm with four 5.5 mm M5 clearance holes on a 60 x 42 mm rectangle; the two toothed cams ride on 6 mm printed pins with retaining heads and are closed by 1.2 mm curved flexure springs, with 4.5 mm guide ribs fairleading the line in.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.