Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Barrier Strip Finger-Safe Guard Hood
A screw-down hood that covers a live screw-terminal barrier strip up to 105 mm long, 27 mm wide and 14 mm tall at the sides (25 mm along the centreline). A continuous 4 mm screwdriver slot along the top lets you retighten terminals at any pitch, and 5 mm comb slots let the wires out on both sides. Every opening is far narrower than a fingertip. Two end tabs take M4 bolts (4.5 mm holes) or #6 wood screws, so it fits any strip on a bench PSU, relay board or junction panel.
Flip-Up Toggle Switch Safety Guard
A surface-mount safety cover that prints in place with its hinge. It goes over an arming or power toggle or rocker on a robot, RC or marine control panel. The 44 x 50 x 3 mm base plate has an 18 x 34 mm window for the switch body and nut, and four 3.4 mm M3 clearance holes placed outside the lid. The hinged 24 x 46 mm lid leaves 19 mm of headroom above the plate for the lever and has a finger lip at the front.