Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
5/8 in Arbor Saw Blade Wall Peg
This wall peg holds a stack of up to about 15 circular saw blades with 5/8 in (15.9 mm) arbor holes, such as 7-1/4 in and 10 in blades, by their centre holes so the teeth never rub together. The backplate is 50 x 110 mm and screws up with two countersunk #10 wood screws. The 15.2 mm peg gives 48 mm of usable length, and a 4.5 mm cross-hole at the tip takes a 4 mm pin or a zip tie to keep the stack from sliding off.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.
Twelve-Slot T-Shank Jigsaw Blade Block
A two-tier bench block that holds 12 T-shank jigsaw blades upright with their teeth showing, so you can grab the right blade without digging through a pile of cardboard sleeves. It is 110 x 44 x 32 mm and has two staggered rows of six 2.4 x 11 mm slots, 12 mm deep. The slots fit common blades from about 1.3 mm thick and up to about 10 mm wide at the shank, and the rear tier is hollowed out underneath to save plastic.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.