Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Spinner-Cap 1/4 in Hex Bit Driver Handle
A 26 mm fluted palm driver handle, 109 mm long, with a 14 mm deep socket for standard 1/4 in (6.35 mm across flats) hex bits. A print-in-place spinner cap on top lets you keep pressing down with your palm while you twirl a screw in with your fingers. It gives you a proper precision-style driver for the bits already in your drawer when you're working on appliances, consoles and electronics.
1/4 in Hex Bit Offset Stubby Wrench
A flat 133 mm wrench for getting into tight spots. One end has a 12-point socket for standard 1/4 in (6.35 mm) hex insert bits, so you can turn a screw inside a cramped appliance or chair housing in 30° swings where a screwdriver won't fit. The other end is a 6-point box end for M5 hex nuts (8 mm across flats). It prints flat at 9 mm thick, so the turning force runs along the layers, and it has an M4 clearance hole for hanging it up.
Pegboard Driver And Plier Bar
A 126.2 W x 50 D x 60 H tool bar for standard 1/4 in pegboard (6.35 mm holes on a 25.4 mm grid), part of the '1/4 in Pegboard Locking-Peg Tool Wall' kit. It has six chamfered drop-through holes (8, 10 and 12 mm, for screwdriver shafts up to about 7, 9 and 11 mm) and two 10 x 28 mm plier slots. It hangs on two of the kit's printed octagonal hook pegs at X ±50.8 mm and is locked by two split, ridged lock pins 25.4 mm lower, through 5.8 mm octagon sockets in the 5 mm back plate.
Eight-Slot Screwdriver Wall Rack
A 170 x 36 mm wall plate with a 29 mm deep gusseted shelf carrying eight graduated open-front slots (3.6 / 4.2 / 4.8 / 5.4 / 6.0 / 6.6 / 7.4 / 8.4 mm) on 20 mm centres, so screwdrivers, nut drivers and files from 3 to 8 mm shaft drop in from the front and hang by the handle. Four 4.5 mm M4 clearance holes mount it to a wall, cabinet side or shop cart, and five 45-degree gussets carry the load in the XY plane instead of across layer lines.