Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
19 in Rack Rail Patch Cable Finger
This open-top cable finger bolts into one 1U space on any 19 in EIA-310 rack rail. It gives you a 59 x 22 mm cable bay, about 20 Cat6 patch leads, in place of a $15–30 commercial D-ring. The two mounting slots are 6.6 x 8.6 mm on 31.75 mm centres, so they take M6 cage-nut screws as well as 10-32 or 12-24 screws. A screwdriver port through the front lip reaches the upper screw. The part prints on its side, so the weight of the cables loads the layers along their length, not across them.
PC Chassis Edge Snap Cable Dress Clip
A screwless cable clip that pushes onto any 0.8–2.0 mm sheet-metal edge, like a PC case rail, a server chassis lip or an enclosure cutout. Its tapered wedge slot narrows from 2.2 mm to 0.6 mm and pinches the panel. On top it has three snap-in C-channels with 7.3, 5.3 and 4.3 mm bores, for coax up to about 7 mm, USB/SATA round leads and fan wires. The clip is 42 x 26 x 15 mm and prints flat, so the snap rings and prongs flex in the strong XY plane.