Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Rain Shower Arm Wall Brace
A screw-to-wall truss brace that holds up a long, sagging rain-shower arm with a 90° V-saddle sized for 19–22 mm OD arms (1/2" IPS pipe is 21.3 mm). Zip-tie slots strap the arm down. The saddle supports the arm 50–112 mm out from the wall and clears a cover plate up to about 80 mm across. Two 5.5 mm holes take #8/#10 screws, with a driver access hole for the top screw. Overall 112 x 117 x 20 mm.
150 mm Oversize Shower Arm Cover Plate
A 150 mm escutcheon plate that slides over a standard 1/2 in IPS shower arm (21.3 mm OD; 22.5 mm bore) and covers a rough wall hole up to about 140 mm across. Most "oversized" plates in stores stop around 100 mm. It prints face-down so the visible face comes out smooth. The 10 mm deep ribbed back reaches over uneven tile, an M4 set screw in the collar grips the arm, and a weep notch at the bottom lets trapped water drain out.
Shower Arm Clamp-On Handheld Shower Cradle
A tapered cradle for a handheld shower head that clamps onto a straight, horizontal 1/2 in shower arm (21.3 mm OD, 22 mm bore), so you don't need to drill the tile. The cone tapers from 19 to 31 mm ID to fit most handles, a 16 mm front slot lets the hose slip in, and one M4 x 30 screw and nut pinch the clamp tight. Slide it onto the arm before you screw the diverter back on.
Split Shower Arm Escutcheon Flange
An oversized 78 mm split escutcheon that clamps onto a 1/2 in NPS shower arm (21.3 mm OD) to hide the chipped drywall or tile hole left after an arm swap — the stock 50 mm flange never covers it, and you can't buy a split one without a whole arm kit. It prints as one piece: a 1.2 mm living-hinge ligament at the rim lets the two halves swing open around the arm in place, then one M3x20 screw through the 3.4 mm lug into the 2.6 mm self-tap pilot pulls the 21.8 mm bore tight. 78 mm dia x 16 mm tall, 2.6 mm brim, print in PETG.