Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Tension Pole Caddy Screw-Lock Shelf Stop
This is a replacement shelf stop for telescoping shower caddy poles from 16 to 32 mm in diameter, for when the shelf's plastic locking tab breaks. An M5 screw runs through a captured M5 nut and pushes the pole into a 90° V-jaw, and the shelf sleeve rests on the 58 x 42 x 16 mm collar. Slide it onto the pole from the bottom end, set the height and tighten an M5 x 35–40 mm screw.
Flex-Fin Soap Pump Bottle Wall Holster
A screw-on wall holster for refillable soap, shampoo and lotion pump bottles 62–76 mm in diameter. Five flexing fins grip the bottle, so you can press the pump with one hand without it sliding around or falling over. The 77 mm bore has a 3 mm drained floor and hangs on three #8 wood screws (5 mm clearance holes). Overall size is 82 x 86 x 100 mm.
Tension Pole Caddy Replacement Shelf
A 120 x 90 mm draining shower shelf that replaces a cracked or lost tray on a corner tension-pole shower caddy. Instead of a moulded collar sized to one pole, it has a 90° V-saddle that seats any pole from 22 to 30 mm. Two worm-drive hose clamps (bands up to 12.7 mm wide) run through 14 x 3.2 mm tunnels in the 62 mm tall clamp block and hold it in place. The floor has drain slots, two gussets carry the shelf load into the clamp block, and the front lip is lowered so bottles lift out easily.
Shower Caddy Suction Cup Rail Hanger
This is a replacement suction-cup corner for a hanging shower caddy (44 x 80 x 18 mm). Its keyhole has an 11 mm entry and a 5.5 mm slot, which takes a standard mushroom-head suction cup or an M5 threaded-stud cup. A 6.5 mm channel holds a 4–6 mm wire or rod top rail, and two M3 cross-screws keep the rail in, so you can fix a caddy whose corner snapped off instead of throwing it away.