Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Corner Tub Curtain Rod 90° Elbow
A replacement 90° elbow that joins two straight shower-curtain rod sections around a corner tub or walk-in tub, so you don't have to buy a whole new L-rod kit. Each 26 mm socket is 33 mm deep and takes 3/4" EMT (23.4 mm OD) or rod tube up to 25.4 mm (1"). An M4 heat-set insert and set screw in each socket clamps the tube. The corner has an M5 through-hole with a captured-nut pocket for a ceiling drop-rod support. Overall size is 67 x 67 x 42 mm.
1/2 in EMT Clawfoot Shower Rod Drop Tee
A set-screw tee for DIY clawfoot tub shower curtain rods made from 1/2 in EMT conduit (17.9 mm OD). The horizontal curtain rail passes straight through an 18.3 mm bore, and the vertical ceiling drop sits 30 mm deep in a top socket. Three M4 self-tapping set screws (3.4 mm pilots) lock both tubes. The body is 50 x 28 x 60 mm, and the rail bore has a teardrop top so it prints without supports.