Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi 4 Slide-In Cluster Blade Sled
A 112 x 70 mm slide-in sled for a Raspberry Pi 4B/3B+. It has four 6 mm standoffs on the 58 x 49 mm hole pattern with 2.9 mm M2.5 through-bores and 6.4 mm nut/head recesses underneath. The 3 mm floor has vent slots and works as a 4 mm tongue down each side, so it slides into any 3.5 mm card-guide slot or rack groove. A finger-pull tab sits under the USB/Ethernet end, so you can swap cluster nodes without unscrewing anything.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.
Pi Zero Single 18650 Power Sled
An 84 x 62 mm base plate that holds a Raspberry Pi Zero on M2.5 standoffs (58 x 23 mm pattern) next to a slide-in sleeve for one 18650 cell (18.4 x 65 mm). The sleeve is open at both ends for the wire tabs and has a top slot for pushing the cell out. Four M3 corner holes let you bolt the whole power pack into a robot or project box.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.