Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Throttle Cable Z-Bend Forming Block
A 90 x 40 x 12 mm bench block that turns six M4 hex-head bolts into steel bending posts, so you can put a clean Z-bend in mower, generator or go-kart throttle/choke wire up to 2.5 mm. Three stations set the Z-leg at 7, 9 or 11 mm pin centres. That lets you cut generic bulk control cable to any length and finish it yourself instead of buying an OEM cable that only comes in one length.
Small Engine Air Filter Cover Snap Latch
This screw-on replacement latch fixes chainsaw, blower and trimmer air filter covers whose molded snap tab has broken off. The 38 x 16 x 5 mm foot screws to the cover through two 4.5 mm M4 holes set 16 mm apart. You drill the cover where the hook reaches the housing. An 18 mm flex arm stands 3 mm off the housing to clear lips up to 3 mm deep, and a thumb tab at the end releases it.
Recoil Starter Pull Handle
Replacement T-handle for the recoil pull starter on a mower, snowblower, generator or pressure washer, for when the original cracks or you re-rope the machine. A 92 mm bar (24 x 20 mm section) carries a 5.5 mm rope bore with a flared conical mouth for 3-5 mm (#3-#5) starter cord, a 15 x 13 mm knot chamber that opens to the build plate so you can tie a figure-8 and pull it in, four 20 mm-spaced finger grooves, and a tapered 7 to 2.2 mm slot at one end that jams the rope to hold the starter extended while you service the deck.