Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Bench Sweep Dustpan With Screw Corral
A small 100 x 80 mm dustpan for the desk or electronics bench. Its front lip tapers to 0.6 mm so it lies flat against the desktop, and a ramped 4.5 mm ridge forms a rear corral that keeps swept M2 screws, solder balls and clipped leads from sliding back out when you lift it. It's 147 mm long including the gusseted 70 mm handle, and the handle has an 8 mm hole for hanging it on a pegboard hook or nail.
Notched Drawer Divider
A 55.2 × 36 × 3 mm snap-in divider for the 'Dovetail-Stacking Parts Drawer Cabinet' kit. It drops into the 3.8 mm rib slots at 30, 60 or 90 mm inside the Detent-Stop Parts Drawer. That fits the 70 × 50 × 130 mm Dovetail Drawer Cell Housing drawer and splits it into 2, 3 or 4 compartments. A 24 × 4.5 mm bottom notch straddles the drawer's 23 mm spine, and a 20 × 6 mm finger scallop lets you lift it out. 0.5 mm chamfers on the side edges help it into the slots. It takes no fasteners.
Print-In-Place Hinged Eight-Bay Parts Case
A pocket case for small parts, 100 x 64 mm and 22.4 mm tall when closed. It has eight bays of about 22 x 29 x 16 mm, sized for screws, nuts, crimp terminals or the spare clips from a repair job. The lid prints lying flat next to the box on a 4 mm pin hinge that comes off the bed already assembled. A locating rim under the lid drops into the box mouth, sits 0.5 mm clear of the dividers so bays stay separate, and a front tab lifts it open.
12 mm Vial Stepped Rack With Pour Tray
A two-tier rack that holds twelve 12 mm OD screw-cap vials or small test tubes upright, one size of loose M2/M2.5 screws, washers or 0402/0603 passives per tube. The back row stands 12 mm taller so you can read the labels. The 12.8 mm bores have chamfered lead-ins, and a 26 x 100 mm pour tray in front lets you tip out a tube, pick what you need and pour the rest back. The rack is 104 x 74 x 36 mm and the sleeves are hollow to keep material low.
Dovetail-Link Drawer Bin
A 100 x 62 x 38 mm open-front parts bin with a vertical dovetail rail on one side and a matching undercut socket on the other, so bins slide together into a row that can't shuffle around in a drawer (116 mm link pitch). The recessed 56 x 8 mm label panel takes a strip of tape, the 28 mm finger scallop lets you reach in, and two M3 clearance bosses (3.4 mm through, 6.6 mm counterbore) let you screw a bin down to a shelf or cleat board instead.