Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Console Lid Snap Hook And Striker Set
A screw-in replacement latch for the centre-console armrest lid on older cars. A flexing barb hook mounts under the lid and snaps into a 5 mm striker window on the console wall. Both mount with #6/#8 screws: the hook through 4.5 mm holes 20 mm apart, the striker through vertical slots 23 mm apart for up to 4.5 mm of height adjustment. The pair prints as one flat 30 × 51 × 14 mm piece and snaps apart at thin breakaway tabs.
Snap-On Pot Rail Hook For 1/2 in EMT
A snap-on S-hook for a DIY kitchen pot rail made from 1/2 in EMT conduit (17.9 mm OD). The 18.3 mm ring clicks over the tube through a 16.5 mm mouth and slides freely along the rail. A 16 mm deep J-hook at the bottom holds pot handles, mugs and utensils. It prints flat and 8 mm thick, so the hanging load runs along the layers instead of across them. It measures about 37 x 87 x 8 mm.