Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Snowblower Shear Bolt Spare Keeper
A 96 x 28 mm keeper that zip-ties into a 90° V-saddle on a snowblower or mower handle tube (fits roughly 16–35 mm OD) and holds four spare shear bolts with their nuts. Each wing has one 6.8 mm hole for 1/4 in or M6 bolts and one 8.6 mm hole for 5/16 in or M8 bolts, so the spares stay on the machine instead of getting lost in a drawer.
Snowblower Sled-Runner Skid Shoe
A replacement skid shoe for a snowblower auger housing. It has a 130 mm sled runner, 22 mm wide and 7 mm thick, that turns up at both ends so it glides over gravel and pavement cracks instead of digging in. The two vertical adjustment slots are 9 mm wide, fit 5/16 in or M8 bolts, sit 70 mm apart by default and give 21 mm of height travel. Measure your old shoe's hole spacing and set BOLT_SPACING to match it.
Snowblower Chute Crank Rod Guide
This replaces the snapped eyelet that holds a snowblower's chute-rotation crank rod against the handle. A 90° V-saddle sits on any 19–32 mm handle tube and is held by two zip ties (up to 5 mm wide) that run through tunnels in the saddle. The 14 mm guide eye takes crank rods up to 12 mm, about 38 mm from the tube. Overall size is 40 x 66 x 24 mm. Print it in PETG for winter use.
Recoil Starter Pull Handle
Replacement T-handle for the recoil pull starter on a mower, snowblower, generator or pressure washer, for when the original cracks or you re-rope the machine. A 92 mm bar (24 x 20 mm section) carries a 5.5 mm rope bore with a flared conical mouth for 3-5 mm (#3-#5) starter cord, a 15 x 13 mm knot chamber that opens to the build plate so you can tie a figure-8 and pull it in, four 20 mm-spaced finger grooves, and a tapered 7 to 2.2 mm slot at one end that jams the rope to hold the starter extended while you service the deck.