Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Tapered-Slot Spoke Nipple Shuffler Tray
A wheel-builder's nipple shuffler. You shake a handful of nipples across 12 parallel slots, and each one drops in shank-first and hangs by its head, ready to pick up with a nipple driver. Each slot tapers from 2.5 to 4.6 mm, so 13–15G brass and alloy nipples of different makes each settle where their shank fits instead of needing one exact width. The tray is 120 x 90 x 22 mm, with 12 mm deep slots, gathering wells at both ends and a V pour spout to tip the leftovers back into the bag.
Lag Bolt And Deck Screw Sort Tray
A 160 x 110 x 28 mm sorting tray for full-size fasteners (M6–M12, 1/4"–1/2") rather than tiny electronics screws. A full-width back lane (156 x 32 mm) holds lag bolts and carriage bolts up to 150 mm (6") long lying flat. Three 50 x 72 mm front bins hold nuts, washers and short screws, and each has a 45° scoop ramp so you can slide the hardware out with a finger.
E-Clip Groove Gauge Sort Tray
A 156 x 64 x 27 mm tray with seven compartments for E-clips. Six of them have a gauge post on the back wall, sized 4, 5, 6, 7, 8 and 9 mm. E-clips are sized by groove diameter, so you snap a mystery clip onto the post it grips snugly and drop it in the bin in front of that post. The seventh bin holds small or odd clips, and a 45° ramp at the front of each bin lets you slide a single clip out with a fingertip.