Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Patio Umbrella Rib V-Jaw Splint
A two-jaw bolted splint that bridges a snapped market-umbrella rib so you don't scrap the frame: two 100 x 42 x 10 mm jaws each carry a 90 degree V-groove 13 mm wide, so opposing V's self-centre round fibreglass ribs from 10 to 18 mm or square-cornered aluminium ribs up to about 12 x 20 mm without drilling the rib. Six M5 x 40 bolts (5.5 mm clearance holes on a 72 x 29 mm pattern) pinch the jaws together, with M5 nuts captured in 4 mm deep hex pockets under one jaw; the jaws print side by side joined by three snap-off tabs.
Ribbed Fence Picket Break Splint
A 70 x 150 mm ribbed splint plate that screws across a cracked or snapped wood fence picket. Use it to fix the one broken board without buying and cutting a new one. It is 4 mm thick with two 10 mm tapered stiffening ribs, and it has eight countersunk 4.8 mm holes for #8 (4.2 mm) wood screws, four on each side of a centre alignment groove. The plate sits flat on any picket from about 75 mm (3.5 in) wide upward, so the board's thickness doesn't matter.
Tent Pole Splint Repair Sleeve
A 120 mm slide-on splint sleeve that repairs a snapped 11 mm tent pole section: 11.4 mm teardrop bore (0.4 mm slip fit), 4 mm walls, tapered lead-in mouths at both ends, and two M3 self-tapping set-screw bosses (2.6 mm holes) that pin it to each pole half so it can't migrate off the break. A centre notch in the full-length stiffening rib lines it up on the crack; overall 120 x 19.4 x 22 mm with a flat printed pad on the bottom. Print in PETG or ASA for UV and cold tolerance.