Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Patio Umbrella Folding Crank Handle
A replacement crank for patio umbrellas (Hampton Bay-style market umbrellas) whose handle has snapped. It has a split collar with an 8.3 mm bore, closed by an M4 bolt into a captured nut, that clamps 7.5–8.3 mm round or D-flat spool shafts. The folding grip on the end is print-in-place. The crank radius is 70 mm, the part is 152 mm long overall, and the grip folds flat in line with the arm when you're not winding. It prints collar-upright, so the clamp and winding torque both stay in the layer plane.
Gas Strut Sag Stop Clamp
A split collar that clamps onto the exposed 8 mm chrome shaft of a gas lift support so a tired hatch, hood, toolbox lid or camper door cannot sink shut — an 8.4 mm slip-fit bore, a 28 mm flange that bears flat on the strut's gland, and two M3 pinch bolts with captured M3 nuts (5.7 mm hex pockets). 36 mm tall overall, printed shaft-axis-vertical so the load is compression through the layers, not peel.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.