Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Split Loom 45° Branch Y Trough
A screw-down Y fitting for split-loom harnesses. A 26 mm main channel takes the trunk run, and a 20 mm branch at 45° takes the wires that split off, so you don't have to tape two looms together at the junction. Under-floor zip-tie grooves let a tie wrap each loom end even after the part is screwed flat, and three 4.5 mm holes take #8 screws. It's 112 mm long and 22 mm tall.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.
Split Loom V-Saddle Screw Mount
A one-size screw-down saddle for routing split-loom wire harnesses. Its 90° V-cradle is 20 mm wide and 10 mm deep and centres any loom from 6 to 25 mm OD. Two 5.5 x 2.4 mm tunnels under the cradle take zip ties to strap the loom down, so you don't need a multi-pack of P-clips to get the one size you want. The footprint is 60 x 40 x 16.5 mm. The two 4.5 mm holes on 44 mm centres take #8 wood screws (4.2 mm shank) or M4 bolts, for car, boat, garage or control-panel wiring.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.