Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
3/4 in PVC Sprinkler Zone Snap Tag
A snap-on zone tag for 3/4 in schedule 40 PVC (26.7 mm OD) irrigation manifolds and valve-box risers. It has a 27 mm C-clip bore and a 22.7 mm mouth, so it clicks onto the pipe without tools. The 66 x 32 mm paddle has a recessed panel for paint pen or a label, plus eight snap-off tabs along the top edge. Break off tabs to count out the zone number so it can still be read after the ink fades in the valve box, and use the 4 mm hole to wire on a backup tag.
Sprinkler-Head Bayonet Hide-A-Key Canister
A buried key safe disguised as a pop-up sprinkler head. The 36 mm OD × 80 mm canister has a 30 mm bore that takes a house key or two, plus drain holes in the floor. A black 44 mm sprinkler-style cap locks onto it with a two-lug bayonet and a 40° twist, and has a coin slot so you can open it with a coin.
1/2 in PVC Sprinkler Riser Tripod Hub
A tripod hub that turns four lengths of 1/2 in Schedule 40 PVC (21.3 mm OD) into a free-standing tall sprinkler stand that throws water over tall vegetable beds. The three 38 mm deep leg sockets splay out at 25°, a 21.7 mm slip bore runs through the centre for the riser, and an M4 thumb screw locks the riser at any height. Footprint is about 112 mm across and it stands 50 mm tall.
Sprinkler Head Mower Guard Collar
A 130 mm sloped ring that sits flush in the turf around a pop-up spray or rotor sprinkler head. Its 70 mm bore clears caps up to about 65 mm across, and the 19° ramp lets mower wheels and trimmer line ride over the head instead of snapping it. Four 5.5 mm holes take tent pegs, 6 in nails or landscape staples to hold it down, and the part is 11 mm tall at the bore with a 1.6 mm outer edge.