Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi 4 Over 2.5 in SSD NAS Tray
Open stacked tray that carries a Raspberry Pi 4 (58 x 49 mm pattern, M2.5 nut pockets in 10 mm posts) on the floor and a 2.5 in SATA SSD above it on four pillars, screwed through the drive's standard side holes (M3, 76.6 mm apart, 3 mm up from the drive bottom, SFF-8201). Both the SSD connector and the Pi USB ports face the same end so the USB-SATA cable loops straight across; 112 x 80.5 x 42 mm with four 4.5 mm screw holes for shelf or wall mounting and vent slots under the Pi.
Bare Drive Storage Rack
A slotted bench rack that stands loose bare drives on edge: three 28 mm slots for 3.5" HDDs (26.1 mm thick) and three 11 mm slots for 2.5" SSD/HDDs (7 and 9.5 mm). Drives sit 7 mm clear of the base so the SATA edge stays accessible and nothing rests on the PCB; 145 x 76 x 30 mm overall with two M4 clearance holes for screwing it down to a shelf.