Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Maker Circle And Hex Nut Drafting Template
This 170 x 70 mm drafting stencil lets you sketch enclosures, brackets and panels at 1:1 scale. It has circles from 2 to 14 mm, 1:1 outlines of 624, 625 and 608 bearings (13, 16 and 22 mm), and outlines of M3, M4 and M5 hex nuts (5.5, 7 and 8 mm across flats). Each opening is cut 0.6 mm over nominal so a 0.5 mm pencil traces the true size. The circles have centre-line notches, one edge has a scale notch every 5 mm, and two raised rails underneath hold the stencil off the paper so ink doesn't smear.
Hinged SMD Stencil Paste Jig
A print-in-place hinged jig for applying solder paste through an SMD stencil: the 95 x 80 mm base deck has a 70 x 50 mm pocket 1.6 mm deep that holds a standard FR4 board flush with the deck, and a 95 x 62 mm frame folds over on a 5 mm print-in-place hinge so the stencil stays registered while you squeegee. Two 11 mm ejection holes push the finished board out from below, and two M3 clearance holes tie the jig down to the bench.