Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place 25 mm Webbing Swivel
A print-in-place swivel that joins two 25 mm (1 in) webbing loops and lets the strap spin freely, so a dog lead, tie-down or gear lanyard stops twisting up. Both slots are 27 x 6 mm. A 14 mm biconical head turns inside an octagonal hub with 0.5 mm clearance and takes the load on a 45° cone along the print plane. The part is 68 x 36 x 20 mm and prints with no supports.
Print-In-Place 25 mm Webbing Cam Buckle
A print-in-place cam buckle for 25 mm (1 in) webbing. It replaces the cracked buckle on a tie-down, roof-rack or tote strap that is normally only sold as a whole strap. A toothed eccentric cam pivots on 5 mm integral stubs in 6 mm cheek bores, closing a 1.5 mm strap gap down to about 0.6 mm, and the fixed end loops round a 10.5 mm slot behind the bar. The buckle measures 35 x 53 x 21.5 mm.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
SG90 Side-Lying Clamp Strap
This inverted-U strap is part of the 'SG90 Sawtooth-Foot Inchworm Crawler' kit. It clamps an SG90 servo lying on its side onto the chassis pedestal, gripping the body so no screws go through the servo's fragile ears. The strap is a 46 x 10 x 4 mm bridge with two 12 mm legs on a 38 mm spacing and a 30 mm inner gap. Each leg has a 3.4 mm hole and a 6.2 mm head pocket open at the end, and takes an M3x16 screw into the pedestal's M3 heat-set inserts.
Side-Release Buckle For 20 mm Webbing
A print-in-place side-release (Fastex-style) buckle for 20 mm / 3/4 in webbing, printed already buckled — two sprung barb legs snap into windows in the female rails, press both sides to release. Overall 76 x 27 x 8.5 mm, with 21 x 3.5 mm webbing slots in both halves and 0.5 mm clearance on every mating face. Replaces the snapped buckle on a backpack, dog collar, tool bag or ratchet strap when the original is unobtainable.