Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Hot Tub Cover Strap Ladder-Lock Anchor
A screw-on tie-down anchor for a hot tub cover. It replaces the snapped plastic strap clip with a two-slot ladder-lock cam bar for 25 mm (1 in) webbing, so you don't have to buy the whole strap. The plate is 52 x 80 mm and sits on two 6 mm stand-off rails, so the strap can run behind it. It mounts to the spa skirt with four #8 pan-head screws through 4.6 mm holes.
Pool Winter Cover Barbed Cable Cinch Clip
A 60 x 36 x 14 mm clip that replaces the cracked UV-brittle clips holding a winter pool cover to its perimeter cable. You fold the cover hem around the cable and push it into the barbed V-channel, which tapers from 10 mm down to 3 mm, so cable-and-hem bundles from about 3 to 9 mm thick lock in place. A 6 x 26 mm slot beside it takes an anchor strap, bungee hook or tie-down for straps up to 25 mm wide. The clip prints flat, so the pull on the strap stays in the layer plane.
Slotted Furniture Anti-Tip Strap Anchor
A 90 x 34 mm furniture anti-tip anchor with one 50 mm slot and a 9.5 mm counterbore. Two #8 or #10 wood screws (4.2/4.8 mm) go in at any spacing up to about 45 mm, so it lines up with holes already in a dresser or bookcase back. The 25 mm webbing strap passes through a 26 x 4.5 mm slot and pulls along the plate, not across the layer lines. Print two: one for the furniture and one for the wall stud.