Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
4S2P 18650 Frame-Strap Battery Box
A low-profile open-top tub for a DIY 4S2P pack of eight 18650 cells (18.4 x 65 mm) laid in two layers of two, with an internal bay of 134 x 39 x 39 mm. The outside measures 144 x 44 x 45 mm. Two 22 x 3.2 mm strap tunnels run through the 6 mm floor so velcro straps hold it to a down tube or frame triangle. There's a 16 x 10 mm main-lead notch at one end, an 8 x 6 mm balance-lead notch at the other, and four M3 heat-set columns to screw on a flat lid. It's for an e-bike, scooter or robot pack you build yourself.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
E-Bike Downtube V-Saddle Battery Mount
An 84 x 60 mm saddle with a 90° V-groove that centres on any round bike downtube or frame tube. It holds a battery tray, bag plate or bottle cage on a frame that has no bosses. Two 20 x 3 mm strap tunnels take hose clamps or Velcro straps, and four 5.5 mm M5 clearance holes on a 66 x 38 mm pattern bolt your accessory to the flat base.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
Underboard Pedal PSU Strap Hanger
A 130 x 60 mm plate that screws to the underside of a pedalboard with four slotted #6 wood-screw holes. A 20 mm hook-and-loop strap runs through two 23 x 3.5 mm tunnels to hold any daisy-chain or isolated pedal power brick up to about 100 mm long. Raised ribs keep the brick 5 mm off the plate for airflow, clear the screw heads and stop the brick rattling loose.
Fire Extinguisher V-Cradle Strap Bracket
A wall bracket with a V-shaped cradle that centres any fire extinguisher body from about 70 to 130 mm across, which covers typical 2.5 to 10 lb units. It replaces a cracked OEM strap bracket in a garage, RV, boat or kitchen. The plate is 140 x 42 mm, the arms reach out 50 mm, and it mounts with two #10 or M5 screws through 5.5 mm holes. A 25 mm hook-and-loop strap or 1 in webbing runs through the 27 mm slots at the arm tips. Measure your extinguisher body before you order. For vehicles, fit one near the top and one near the bottom of the body.
Trail Camera Tree Strap Mount
A 45 x 86 mm strap plate that replaces the cracked OEM trail-camera tree mount: two 27 x 5 mm slots take a 1" (25.4 mm) camera strap or ratchet strap, and a 10 deg wedge boss carries a captured 1/4-20 hex-head bolt (side pocket 11.6 mm across flats, 6.8 mm shank bore) so the camera threads straight on and aims downtrail. Four 5.5 mm corner holes let you lag-screw or M5-bolt it to a post instead, and the bolt head recesses flush so the back sits flat on bark.