Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Stud-Mount Olympic Weight Plate Horn
This wall horn screws flat to a 2x4 stud face (38 mm, matched by the 28 mm-wide backplate) with two #10 wood screws (5.5 mm holes, 102 mm apart). It holds 2 in Olympic plates (50.8 mm bore) on a 30 x 28 mm I-section horn that angles up 8° and ends in a stop lip. The part prints on its side, so the bending load stays in the layer plane instead of peeling layers apart, and it replaces a $60 steel plate tree with one 130 mm-tall bracket.
2x4 Open-Stud Straddle Cord Hook
A heavy hook for open-stud garage walls. A U-channel slides over the 38 mm (1.5 in) front edge of a 2x4 stud and holds with two #8 wood screws through the side legs, which have 4.8 mm clearance holes. A gusseted 70 mm arm with a 35 mm upturned lip then carries extension cords, air hoses or ropes without adding a backer board.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.