Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pedalboard Six-Lane Patch Cable Raceway
This low-profile raceway clip screws to a pedalboard slat and holds up to six patch cables. Cables 5–7 mm across press through a 5 mm mouth into 7.5 mm lanes and stay put. The clip is 90 x 20 mm and only 13.5 mm tall, so it fits under most pedal overhangs. Two 4.5 mm holes take #6/#8 wood screws or M4 bolts, and the flat base also takes hook-and-loop tape.
Eurorack 3U Rail End Bracket
This L-shaped side bracket turns a plywood box into a Eurorack 3U case. Its two vertical 5.5 × 16 mm slots are 122.5 mm apart, matching the 3U panel hole pitch, and they take an M4 or M5 rail-end screw with ±5 mm of adjustment, so different rail profiles still line up. You screw it to the case floor and side with #8 wood screws (4.8 mm holes). It is 155 mm tall and 30 mm deep, and it prints lying on its L profile so rail loads run along the layers.