Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
T8 LED Shop Light Tube Snap Clip
Screw-mount snap clip for 1 in (25.4 mm) T8 LED shop-light tubes. The 25.8 mm bore takes tubes from about 25–26 mm, a flared 21 mm mouth snaps them in, and two 4.5 mm holes 42 mm apart take #8 wood screws or M4 bolts. It replaces the clips that come with linkable garage shop lights, which go missing, or holds a direct-wire tube to a joist or shelf. The clip is 56 x 35 x 14 mm and prints flat, so the snap arms flex in the strong layer plane.
NEMA17 Leadscrew Motor End Block
Motor-end block for a DIY linear actuator. It holds a NEMA 17 stepper on the 31 mm M3 bolt pattern and 22 mm pilot, with two 8 mm guide rods 60 mm apart, each locked by an M3 heat-set grub screw. A flanged foot with M5 holes bolts it to 2020 extrusion or a baseplate, and gussets carry the load.