Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Three-Hole Guyline Tensioner Four-Pack
A snap-apart sprue of four flat three-hole guyline tensioners (45 x 14 x 4.5 mm each, 65 mm across the pack). They replace the lost or cracked sliders on tent, tarp and hammock-fly guylines. The 4.5 mm holes take 2–4 mm cord, up to 550 paracord, and both faces of every hole are chamfered so the cord grips without fraying.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Tarp Bungee Ball Knot-Pocket Replacement
A replacement for the hard ball on a tarp ball-bungee: a 32 mm dome with two parallel 6.5 mm bores that take a 4–6 mm shock cord loop, a recessed pocket on top so the end knots sit flush, and a 45° V-groove around the middle where the loop hooks back over. It's 32 mm across and 25 mm tall, prints without supports, and replaces the balls that crack or go missing on truck-bed, trailer and firewood tarps.
Bolt-Through Tarp Grommet Repair Patch
This patch replaces a torn tarp, pool cover, awning or shade-sail grommet without a grommet-setting tool. Print two identical 56 mm discs, put one on each side of the fabric and bolt them together with four M4 x 16 mm screws. The 12 mm centre eye takes rope, bungee hooks or tent stakes. Each disc has 4.5 mm clearance holes on a 36 mm bolt circle, a hex pocket that holds either an M4 nut (7 mm across flats) or the screw head, and two raised ridges that grip the fabric. The outer edge is chamfered so it won't saw through the tarp.
Captive Cone Tarp Clamp
A grommet-free tarp clamp that grips any tarp, canopy or greenhouse film anywhere along its edge: drape the fabric over the 19.4 mm funnel mouth and press the captive cone plug (Ø8 → Ø22.7 mm over 23 mm) down into it — the plug's steeper 16.7° taper wedges the fabric against the funnel's 11.3° wall, and because the crown is wider than the mouth the plug prints in place and can never be lost. The 68 x 32 x 23 mm body carries a 10.4 mm rope eye for paracord, bungee hooks or an S-hook, plus a 5.5 mm M5 clearance hole so it can bolt directly to a post or frame instead.