Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Probe Oscilloscope Hook-Tip Wall Rack
A 110 x 26 mm wall rack that holds four oscilloscope probes tip-down. Each one sits in a tapered funnel that runs from 17.5 mm across at the top to 8.5 mm at the bottom, so hook-tip caps up to about 8 mm pass through and probe bodies between 9 and 17 mm wide come to rest in the taper. A 2.5 mm fin along the top gives the alligator ground leads something to clip onto, and the rack fixes to a wall or the side of a shelf with two #8 screws through 4.5 mm holes.
DE-9 CAN Bus Bench Breakout Box
An 80 x 60 x 35 mm bench breakout box for CAN bus work. A panel-mount DE-9 connector goes in the front: 20 x 11.5 mm window and 3.4 mm screw holes 25 mm apart. The back has four M4 terminal-stud holes (4.5 mm) so you can clip probes onto CAN-H, CAN-L, GND and power. The lid screws into four M3 heat-set insert bosses at the corners.