Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Size Alligator Clip Boot Sprue
A snap-off sprue of four tapered slip-on insulating boots to replace the cracked rubber boots on alligator and crocodile clip test leads. Jaw-end openings are 7x5, 10x7, 14x10 and 18x12 mm, the boots are 22, 28, 36 and 44 mm long, and the wire holes are 3.0, 3.6, 4.5 and 5.5 mm. Each boot has a finger-stop flange, so you can re-boot your clip leads without buying a whole new set. Measure your clip's handle and pick the boot just over that size. Print in TPU if you want a softer boot.
Eight-Lane Test Hook Clip Comb Stand
A 90 mm wide, 50 mm tall bench stand with eight tapered sockets on a 10.5 mm pitch. Each socket narrows from 8.5 mm at the top to 4 mm and is open at the bottom, so test hook clips and grabber probes of different body sizes drop in and wedge upright with their leads hanging free. The 45-degree comb bar and end gussets print without supports, and two 3.4 mm holes let you screw it to the bench with M3 or #6 wood screws.
Universal Multimeter Tilt Stand With Probe Holsters
A replacement for the snap-off kickstand on a cheap multimeter. The meter sits in a 96 mm wide cradle against a 16 mm front lip and leans back 30° on a gusseted rest, so any meter up to 96 mm wide and about 45 mm thick fits without needing its own dimensions. Two 10.5 mm holsters at the sides hold test probes with grips up to 10 mm across. The stand measures 134 x 104 x 80 mm, and the backrest and floor have cut-out windows to save plastic.
Test Lead And Clip Wall Rack
A 150 mm wide wall rack with ten 5.2 mm drop-in slots. Each slot takes a meter lead or patch lead with wire up to about 5 mm OD, and the banana plug or probe body rests on top so the leads hang straight and don't tangle. A 3 mm clip rail along the top holds alligator and hook clips. Two gussets and the center rib brace the 40 mm deep shelf. Mount it with two #8 wood screws or M4 bolts through the 4.6 mm holes, which are 90 mm apart.