Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Bike Thru-Axle And QR Skewer Wall Rack
A 150 x 42 x 45 mm wall rack that holds pulled bike axles head-up. It has two 15.8 mm slots for 15 mm thru-axles, two 12.8 mm slots for 12 mm thru-axles and two 5.8 mm slots for 5 mm QR skewers, so they stop rolling around the workbench while wheels are off. It mounts with three 5.5 mm holes for #8/#10 wood screws or M5, and it prints standing on its end so a gusset carries the axle load along the layers.
12 mm Thru-Axle Chain Keeper Dummy Hub
A dummy rear hub that clamps between the dropouts of a 12 x 142 mm thru-axle frame so the chain stays taut and the derailleur stays put while the rear wheel is out for washing, chain cleaning or car transport. The 142 mm long body has a 12.5 mm bore for the 12 mm axle, 24 mm end caps that bear on the dropout faces, and a captured print-in-place roller (33 mm OD, 8 mm wide groove floor, 45 degree flanges) centred 25 mm from the drive-side face to sit near the cassette chain line; two snap-off 3 mm spacer rings bring it to 148 mm for Boost frames. Print standing on its end cap and put a dab of grease in the roller.
15x100 Thru-Axle Fork Mount Block
A bolt-down fork mount for a 15 x 100 mm thru-axle bike: the 99 mm wide crossbar slips between the fork dropouts and a 15.3 mm teardrop bore takes the axle, so a van floor, truck bed or plywood work stand gets a real fork mount instead of a $50 machined adapter. Base is 104 x 52 x 6 mm with four M5 clearance holes on an 80 x 38 mm pattern; axle centre sits 40 mm above the deck, gusseted fore and aft against fore-aft tipping. Boost 15 x 110 forks add a 5 mm spacer per side.