Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Single-Gang Flanged Box Extender Ring
A flanged extender sleeve for a single-gang device box that ended up sitting too deep behind new tile or drywall. It adds 16 mm of depth. A 2.5 mm flange (64 x 100 mm) rests on the finished wall under a standard 70 x 114 mm cover plate. Two full-depth screw columns have 4 mm stadium slots. They pass the long 6-32 device screws (about 3.5 mm) at any centre spacing from 77 to 89 mm, which covers the common 83.3 mm (3-9/32 in) box-ear spacing. The inner 48 x 70 mm liner keeps wires away from the raw edge of the wall cut-out.
Three-Size Tile Drill Guide With Water Cups
A 120 x 50 mm drill guide that you tape to glazed wall tile so the bit doesn't skid when you drill holes for towel bars, grab-bar anchors, shower caddies or toilet-roll holders. It has three 22 mm tall guide towers for 6, 8 and 10 mm tile or glass bits (bores 6.3, 8.3 and 10.3 mm). Each tower has a water cup on top that drips coolant down the bore to the bit tip, and V-notches on both edges line each tower up with your pencil crosshair.
Tub And Tile Caulk Tool
A one-piece 100 x 50 x 10 mm caulk finishing and removal tool for re-sealing a tub, shower pan or vanity backsplash: its four working corners are rounded to 5, 8, 12 and 16 mm so each one lays a matching concave silicone fillet while the two adjacent flats ride the walls of the 90° joint. The opposite side carries a 26 mm wide scraper blade tapered to a 1.8 mm plastic-razor edge for lifting old silicone off tile without scratching it, a narrow rake point for digging the joint out, and a 4.5 mm hole for an M4 screw or nail to hang it.