Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Kids Light Switch Slide Extender
A print-in-place slide extender that mounts under the two screws of a standard US single-toggle wall plate (60.3 mm / 2-3/8" screw spacing, 6-32 screws through 4.5 mm holes). A captured 22 mm wide slider with a 12 x 14 mm toggle window and a pull tab 78 mm below the toggle lets small kids reach the switch.
Compliant Bistable Snap Toggle
A one-piece flexure mechanism: four pre-bent 1.2 mm beams hold a centre shuttle in one of two stable positions about 5.4 mm apart, and it snaps between them with a click. Push rods stick out both sides. The 84 x 50 x 6 mm frame screws down through four M3 clearance holes, so you can use it as a latch, a microswitch trigger, or a detent with mechanical memory. Nothing is assembled and there are no pins to wear out.