Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Cat-Proof Toilet Roll Hood
This hood fits over any wall-mounted toilet roll holder so cats and toddlers can't swat the roll and unspool it. The open bottom still lets the paper feed out, and the flat top doubles as a phone shelf. The hood is 120 mm wide for standard 4.5 in (114 mm) rolls and clears rolls up to 125 mm across. It reaches 144 mm out from the wall. It hangs on a 3 mm tab with two 4.5 mm holes for #8 wood screws or M4 screws. Mount it with the top surface about 85 mm above the holder's spindle.
1-1/4 in Grab Bar Toilet Roll Arm
This U-saddle drops onto a standard 1-1/4 in (31.75 mm) grab bar and is locked in place by an M4 screw. It carries a 115 mm cross-fin spindle that sits 80 mm off the bar axis, so a standard roll (42 mm core, up to about 120 mm OD) hangs clear of the bar and the wall. It lets you put the toilet paper where a seated user can reach it, with no new holes in tile and no need to trust a second set of wall anchors.
1 in PVC Spare Toilet Roll Tower Base
A freestanding 150 mm spoked base that holds 1 in Schedule 40 PVC pipe (33.4 mm OD) upright in a 40 mm deep slip-fit socket (33.9 mm bore). Stack spare toilet rolls on the pipe next to the toilet: cut the pipe to whatever height you want, with no drilling and no wall anchors. A drain hole in the socket floor lets mop water run out.
Mega Roll Toilet Paper Arm
Wall-mounted single-arm toilet paper holder sized for modern mega/jumbo rolls: the spindle axis sits 90 mm out from the wall face, so a 140 mm diameter full roll clears the wall by 20 mm instead of dragging and shredding on the backplate the way it does on a 1980s–2000s builder-grade holder. The ø38 mm hollow post is 112 mm long (104 mm usable past the shoulder) and lets a standard 44 mm roll core spin free; it mounts with two M4 screws on a 38 mm vertical spacing through 4.5 mm clearance holes in a 56 x 22 mm pad. Overall 115 x 56 x 112 mm, printed lying in its bending plane so the cantilever load runs along the layers, not across them.