Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Double-Prong Bathroom Robe Hook
A two-prong robe and towel hook for the back of a bathroom door or wall. It replaces a snapped zinc hook without having to find the brand's hidden-mount base. It is 91 x 60 x 20 mm, and the 80 mm back plate mounts with two countersunk #8 wood screws (4.2 mm shank) through 4.6 mm clearance holes 40 mm apart. The long upper prong reaches 60 mm from the wall and the short lower one 42 mm. Both have ball tips so fabric won't snag.
Oven Door Handle Clamp-On Towel Hook
A towel hook that screw-clamps onto any round oven or dishwasher door bar from 16 to 30 mm across, so it can't slide off. A 90° V-crown sits on top of the bar and an M4 bolt in a heat-set insert (5.5 mm bore) pushes up from below to lock it. It is 16 mm wide and about 75 x 101 mm overall, and needs about 24 mm between the bar's centre and the door.
1-1/4 in Grab Bar Snap-On Towel Hook
A snap-on J-hook that clips onto a standard 1-1/4 in (31.75 mm OD) shower or tub grab bar. It gives you a place to hang a loofah, washcloth or razor strap without drilling tile. The C-clip has a 32.2 mm bore and a 27 mm snap mouth and is printed flat, so the clip flexes in the strong layer plane. The part is 16 mm thick, about 83 mm tall and weighs about 12 cm³.
Over-Door Towel And Robe Hook
A clamping over-the-door double hook for wet towels and robes on a bathroom door: the 38 mm throat and 2.4 mm flexure tongue are squeezed by an M4 screw in a 5.5 mm heat-set bore, so it locks to any 32–38 mm door (a standard 1-3/8 in / 34.9 mm interior door sits mid-range) instead of swinging and scuffing paint. The bridge over the door top is only 3.2 mm thick so the door still shuts, the strap is 22 mm wide, and the part is 82 x 95 mm overall with a robe hook 36 mm down and a deeper towel hook at 82 mm.