Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Towel Ring Screw-Closed Wall Post
This is a replacement wall post for a bathroom towel ring whose small retaining tab has snapped. The top of the ring drops into a 10 mm wide open-top cradle (fits ring wire or tube up to about 9 mm), and an M4 screw across the mouth locks it in. It mounts with two #8 pan-head wood screws through 4.8 mm holes 62 mm apart. It is 56 mm deep, 80 mm tall and 22 mm wide, and it prints on its side so the towel load runs along the layers, not across them.
Wall-Mount Hand Towel Hoop
A towel ring that sticks straight out from the wall. It has a D-shaped opening about 100 x 93 mm that you push a hand towel through. The backplate is 80 x 50 x 6 mm with two 5.5 mm holes 40 mm apart that take #8 or #10 pan-head screws or wall anchors. It prints flat on the hoop, so layer lines run along the arm that carries the load, and two side gussets and a centre gusset brace it against the wall plate.