Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
2 in Hitch Ball Mount Wall Socket
Wall-mounted open-top square socket that stores a standard 2 in receiver hitch ball mount by its shank, so the drawbar stops kicking around the garage floor. The socket is 52.5 mm square inside and 70 mm deep, with 16.6 mm slots in both side walls so the 5/8 in hitch pin and clip pass through the shank's pin hole and lock the mount in place; the 92 x 100 mm back plate takes three #10 wood screws through 5.5 mm holes into a stud.
2 in Hitch Ball Snap-On Weather Cap
A snap-on cap for a standard 2 in (50.8 mm) trailer hitch ball. It keeps rain, grit and grease off the ball, and off your trouser legs. Six slotted fingers flex over the ball's equator and close to a 47.6 mm lip underneath to hold on. It stands 62 mm tall and is 56.8 mm across. The 45° roof prints without supports and sheds water, and a 5.5 mm lanyard eye on top lets you tie it to the safety chain so it doesn't go missing.