Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Trampoline Net Pole V-Clamp Hook
This is a two-jaw clamp that replaces a trampoline safety-net pole clip after sun damage breaks it, so you don't have to buy a whole new net kit. Two facing 90° V-jaws grip any round pole from 22 to 34 mm OD, two M5 x 50–60 bolts with nuts held in hex pockets tighten them, and a 14 mm-deep hook slot holds the net loop or bungee. The halves print side by side on two snap-off tabs and measure 64 x 46 x 30 mm when bolted together.
Trampoline Spring Puller T-Handle
A solid T-handle spring puller for fitting or replacing trampoline springs and mats. It has a 100 × 22 mm palm grip and a 96 mm shank that ends in a J-hook. The hook slot is 6.5 mm wide with a 10 mm deep catch pocket, which holds the wire end hook of a spring so the tool doesn't slip off the way the stamped-steel ones do. It prints flat, so the pulling load runs along the layers instead of across them.