Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Wheelie Bin Pinch-Clamp Axle Bracket
This bolt-on pillow block gives a curbside wheelie bin a new mount for its steel wheel axle after the moulded snap-in mount cracks. Measure your axle first: the split 17 mm bore is meant to pinch about 15.5–17 mm axles, including the common 5/8 in (15.9 mm) size. One M5 pinch bolt with a captured nut tightens the bore. The 96 x 46 x 30 mm block mounts to the bin base with two M5/#10 bolts through 12 mm vertical slots, so you can line it up with the old axle position. Print it on its side so the wheel load runs along the layers, not across them.
125 mm Twin-608 Cart Wheel
A 125 mm diameter x 30 mm wide replacement wheel for hand trucks, garden carts, shop dollies and trash bins fitted with an M8 axle kit. It takes two 608 bearings (8 x 22 x 7 mm) press-fit into 22.05 mm pockets on each face and has a 9.5 mm through-bore for an 8 mm rod or M8 bolt. Six radial ribs over a flat web and a grooved 4 mm tread keep the weight around 90 cm³, and it prints flat with no supports.