Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Six-Cane Garden Teepee Topper Hub
A crown hub that holds six garden canes in a bean or sweet-pea teepee. Each canted socket tapers from 12.5 mm at the mouth down to 8.5 mm, so any bamboo cane from 8 to 12 mm wedges in tight with no tying. The six sockets lean out 15°, which gives a roughly 1 m wide teepee on 2.4 m canes, and an 8.3 mm centre bore takes a hanging cord or an 8 mm rod finial. The hub prints with the sockets facing up and is about 70 mm across.
Cattle Panel Screw-On Wire Snap Clip
This screw-on snap clip holds a 4-gauge cattle or hog panel wire (about 5.2 mm, works with 5–6.5 mm wire) to a wooden post or the side board of a raised bed. It fixes arch trellises and garden fences without bulk-only farm-store clips. The clip is 60 x 16 x 24 mm and attaches with two #10 wood screws or M5 bolts through 5.5 mm counterbored holes. The 7.2 mm C-saddle has a 4.4 mm side mouth with a lead-in, so the wire clicks in sideways, and a pull away from the post loads the closed back of the ring rather than the opening.
Twin-Level Trellis Rod Cross Lock
A cross joint for trellis and plant-support grids. It holds two perpendicular rods, stakes or dowels from 3/8 in (9.5 mm) up to 1/2 in (12.7 mm) on two levels, so the rods pass straight through without being cut. Each rod sits in a 13.4 mm diamond bore and is locked by an M4 bolt threaded into a captured M4 nut. The bolt pushes the rod into the V of the bore, which centres any diameter in that range, including 11 mm coated garden stakes. The block is 26 x 26 x 55 mm. Print it in PETG or ASA and it will outlast the UV-brittle snap clips.