Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Trimmer Line Spool Wall Peg With Eyelet
This wall plate (60 x 120 mm, about 82 mm deep) holds a donut or spool of string trimmer line with a centre hole of 38 mm or more. A cross-ribbed peg 78 mm long has a 4 mm hook-up tip that stops the spool sliding off. Below the peg, a 4 mm eyelet feeds line of 1.6–2.7 mm (0.065–0.105 in), and a 1.4 mm pinch kerf in the bottom edge holds the loose end so the coil doesn't unwind. It mounts with four 5.5 mm holes for #8/#10 wood screws or M5 bolts.
String Trimmer Wall Hanger With Line Hook
A wall hanger for a string trimmer. The lower cradle is 48 mm wide and 18 mm deep, so it takes any shaft or D-handle from 22 to 32 mm, including leaf blower tubes. Above it, a 34 mm hook holds a coil of spare trimmer line, and a 3 mm notch at the tip keeps the loose line end from unwinding. It's 125 mm tall and 28 mm thick and screws to a stud with two #8 or #10 screws through 5.5 mm holes. It prints on its side so the load runs along the layers, and both arms have ribs underneath.