Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Zip-Tie Clamshell Cable Boot Splint
This tapered two-half splint replaces the cracked molded boot behind an RJ45 patch cable or USB plug. It clamps onto cables from 4.5 to 6.5 mm OD: the bore is 6.6 mm with five crush ribs that narrow it to 4.8 mm, and two 4.2 mm zip-tie grooves hold the halves closed. It is 45 mm long and tapers from 18 to 10 mm OD. Both halves print flat as one piece joined by snap-off sprues, so the plug never has to pass through it and a working cable doesn't get binned.
SD MicroSD And USB Drive Dock
A 104 x 46 x 16 mm bench dock that stands up 6 microSD cards (11 x 15 x 1 mm), 3 full-size SD cards (24 x 32 x 2.1 mm) and 4 USB-A flash drives parked plug-down in 12.8 x 5.4 mm bays, so the loose media around a Pi/camera bench stops disappearing into the parts bin. Cards protrude 7–20 mm for a one-finger pinch, a scalloped thumb groove backs the microSD row, and two M3 clearance holes on a 96 mm centre let you screw it into a drawer bottom or shelf; underside relief pockets keep it to roughly 57 cm³.