Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Vacuum Attachment Three-Cone Wall Ledge
A wall-screwed ledge with three hollow tapered cones (37 mm at the base down to 29 mm) that hold vacuum crevice tools, dusting brushes and upholstery heads by their bore. One cone fits both the common 32 mm (1-1/4 in) and 35 mm wand bores from any brand. Overall it is 168 x 60 x 50 mm, with 56 mm cone spacing and two 5.5 mm holes sized for M5 or #8 pan-head screws.
608 Bearing Vacuum Brush Roll End Cap
A replacement end cap for an upright vacuum's beater-bar brush roll. It holds a standard 608 bearing (8 x 22 x 7 mm) in a 22.05 mm press-fit pocket, and a 38 mm hair-guard flange keeps hair from winding into the bearing. The tapered spigot has eight crush ribs that wedge into roller tube bores from about 27 to 32 mm. Your old axle and bearing go straight back in, so you don't have to buy a $25 roller assembly to replace a cracked $5 cap.
32 To 35 mm Vacuum Wand Adapter
Fits a 32 mm vacuum wand to a 35 mm attachment. Both ends are tapered friction fits, so small differences between brands (Shark, Bissell, Hoover, Dyson-style) still seal. The socket tapers from 33.2 to 31.4 mm ID and takes a 32 mm male wand, stopping on an internal shoulder. The male spigot tapers from 35.8 to 34.0 mm OD and plugs into 35 mm tool sockets. The part is 85 mm long with a ribbed grip collar.
Venturi Vacuum Gripper Head
A pick-and-place vacuum head that bolts straight to an MGN12H carriage (20 x 20 mm M3 pattern) and clamps a 4 mm OD PTFE/Bowden vacuum line in a split barrel pinched by a single M3 bolt with a captured nut. A Ø10.5 mm counterbore at the bottom seats a suction-cup collar, and a Ø22 mm scallop with two 4.5 mm zip-tie slots cradles the venturi ejector body alongside. Overall 52.5 x 29 x 52 mm.