Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Screw-On Vertical Blind Valance Clip
This screw-on clip replaces the snapped plastic valance clip on a vertical blind headrail. It fastens to the headrail face or the wall with two #6 wood screws through 4 mm vertical slots with 8 mm of height adjustment. A 6 mm wide, 12 mm deep upward-facing J-channel holds valance back flanges up to about 6 mm thick. The clip is 12 x 40 x 30 mm and prints flat on the plate, so the valance load runs along the layers.
Vertical Blind Vane Top Repair Splint
A bolt-on U-channel splint that slips over the torn top of a standard 89 mm (3.5 in) vertical-blind vane and gives it a new hanger tab. It saves the vane when the punched hook hole rips out on an old headrail you can no longer buy parts for. The 2.4 mm jaw gap takes PVC or stiffened-fabric vanes up to 2 mm thick. Two M3 bolts go through 3.4 mm holes into captured nut pockets: use the splint as a drilling template, then clamp. The 2 mm tab has a 4 x 12 mm slot for the carrier clip's hook.