Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pedestal Sink Single-Lug Wall Hanger
A replacement for the discontinued steel hanger that holds a pedestal sink's back edge to the wall. You print two and screw each one wherever the sink's rear slots land, so any lug spacing works. Each one is 36 mm wide, 80 mm tall and stands 30 mm off the wall, with an 8 x 14 mm upright tab that the sink's slot drops onto. Two vertical 5.3 mm slots take #10 (4.8 mm) wood screws into blocking and give 10 mm of height adjustment. The hook is printed on its side, so the sink's weight never pulls across the layer lines.
French Cleat Guitar Neck Yoke Hanger
A guitar or bass wall hanger that drops onto a standard 45° French cleat. It has two 12 mm tines with a 50 mm gap for the neck just below the headstock, a 96 mm reach so the tuners clear the wall, raised tips that stop the instrument sliding off, and a 4.8 mm hole for an optional #8 screw that stops the hanger lifting off the cleat. It prints on its side, so the guitar's weight bends the arms along the printed layers instead of pulling them apart.
String Trimmer Wall Hanger With Line Hook
A wall hanger for a string trimmer. The lower cradle is 48 mm wide and 18 mm deep, so it takes any shaft or D-handle from 22 to 32 mm, including leaf blower tubes. Above it, a 34 mm hook holds a coil of spare trimmer line, and a 3 mm notch at the tip keeps the loose line end from unwinding. It's 125 mm tall and 28 mm thick and screws to a stud with two #8 or #10 screws through 5.5 mm holes. It prints on its side so the load runs along the layers, and both arms have ribs underneath.