Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Slide-In Zip Bag Spare Parts Rail
This 160 mm wall rail holds zip-lock bags of spare hardware, such as flat-pack cam locks, dowels and leftover screws. You slide each bag's zipper into the 14 x 8 mm channel from the open end. The film passes out through a 1.6 mm slot, so the bag hangs from its zipper bead, and the 45° channel roof wedges the bead in place. It is held to the wall by three countersunk #8 (4.2 mm) wood screws through 4.6 mm holes.
Four-Fin Spring Clamp Wall Rail
A 180 x 44 mm wall rail with four flared fins, 4, 8, 12 and 16 mm thick, that spring clamps grip directly. Mini clamps go on the thin fins and 2–3 in clamps on the thick ones, so they hang in a row instead of sitting in a jumbled bucket. The fins flare by 1.2 mm per side toward the tip so the jaws can't slide off. The rail is held up by two #8 wood screws (4.7 mm holes, 9 mm counterbores) on 90 mm centres. It prints flat with no supports, and the fins are deep in the direction the clamps pull.
Pinned Cleat Rail End Stop
End stop for the 'Printed French Cleat Bin Wall' kit. It is a 20 x 55 x 13 mm block that butts against the end of a 200 mm cleat rail and sits 10 mm above the rail's 45 mm front and 8 mm in front of it, so hangers can't slide off the end. It takes two 4 mm x 20 mm steel dowel pins in 4.3 mm x 11 mm blind holes at d=6, h=10/25, which you can glue with CA. The block is symmetric, so turn it over to use it at the other end of the row.
Printed 45 Degree Cleat Rail
A 200 mm long French-cleat wall rail for the 'Printed French Cleat Bin Wall' kit. It is 12 mm thick and 45 mm tall, with a 45° bevel that the kit's hanger brackets hook onto. It takes three #8 wood screws (4.2 mm shank) through 5.0 x 10 mm slots, with a 10.5 x 15.5 x 4 mm counterbore for the head. Each end has two blind holes 4.3 mm across and 11 mm deep, which take 4 x 20 mm steel pins to join rails end to end. It prints flat on its wall face with no supports.