Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Twin-Size Snap-In Tool Handle Wall Grip
This wall grip has two snap-in C-rings for long-handled garage tools: a 25.4 mm ring for 7/8–1 in broom and mop handles and a 32 mm ring for 1-1/4 in rake and shovel handles. Each ring has a tapered lead-in mouth. The 150 x 44 x 25 mm grip screws to a stud with three #8 wood screws through 5 mm holes. It is printed lying on its side, so the flexing lips and the hanging load stay in the layer plane.
Pegboard Four-Profile Hook Sprue
A snap-off sprue of four pegboard hooks for standard 1/4 in (6.35 mm) hole pegboard on 1 in (25.4 mm) centres, either 1/8 or 1/4 in thick: a 64 mm straight prong with a tip stop, a 40 mm J-cradle for cords, a 30° up-angled prong and a 28 mm stub. When you need one more hook of a particular shape, print this instead of buying a whole $15 kit. Each hook lies flat on the bed, so the load stays in the layer plane. The 4.4 mm square pins are spaced 25.4 mm apart and have a 6.8 mm board gap behind the plate. The sheet measures about 147 x 90 x 8 mm.
5/8 in Arbor Saw Blade Wall Peg
This wall peg holds a stack of up to about 15 circular saw blades with 5/8 in (15.9 mm) arbor holes, such as 7-1/4 in and 10 in blades, by their centre holes so the teeth never rub together. The backplate is 50 x 110 mm and screws up with two countersunk #10 wood screws. The 15.2 mm peg gives 48 mm of usable length, and a 4.5 mm cross-hole at the tip takes a 4 mm pin or a zip tie to keep the stack from sliding off.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.
Pinch-Bolt 1/2 in EMT Rail Parts Bin
A 90 x 60 x 50 mm open parts bin with a 45° V-roof hook that hangs over a 1/2 in EMT conduit rail (17.9 mm OD) above a bench. One M4 x 35 bolt goes through 4.5 mm holes in the bin's rear pillar and the flexing back leg and pinches the rail, so the bin can't rock forward when it's loaded and you can slide it anywhere along the rail. The rail needs at least 25 mm of wall standoff to clear the 3 mm back leg.
Locking-Peg Pegboard Small Bin
A two-column open-top parts bin, 50.0 W x 65 D x 70 H, that is part of the '1/4 in Pegboard Locking-Peg Tool Wall' kit. It hangs on two of the kit's printed octagonal hook pegs and is held by two split, ridged lock pins in standard 1/4 in pegboard (6.35 mm holes on a 25.4 mm grid). The 5 mm back plate has 5.8 mm octagon sockets at X ±12.7 mm, with the hook row at Z 62 and the lock row 25.4 mm below it, so a bump won't lift the bin off the board.